Jaeden, For wiring subwoofers, we recommend using wires of 12- to 16-gauge in size. There will be no audible difference between them - just less power loss with larger wire.
Is 14 gauge speaker wire good for subs?
The signal and power coming out of your amplifier must not be impeded on their way to your speakers and subs. When you replace or run new speaker wiring, we recommend using: 18-, 16-, or 14-gauge wires for speakers. 16-, 14-, or 12-gauge wires for subwoofers.
What happens if speaker wire is too small?
The only problem with using too-thin wire is that if you put enough current through it that it melts, then your amp wont be too happy. The amplifier will be quite happy if the wires melt and fuse, leaving an open circuit with no load.
What size speaker wire is best?
Most systems will use 16, 14 or 12-gauge AWS wire. 16-gauge copper wire can run up to 48-feet with 8-ohm speakers. So, if you want a wire size that will suit most circumstances, then a 16-gauge copper wire is probably a good fit. For speakers with a lower impedance, then you might go with 12 or 14 AWG just to be safe.
Why is one speaker louder than the other?
The reason is that the inherent meter tolerance when reading a noise signal means the two speakers will always end up being slightly different — enough to pull the phantom centre off slightly to one side.
Can I use 14 AWG instead of 16 AWG?
14awg is larger in size than 16awg. There is a distance that you can run 14 vs 16awg and not lose performance based on ohm load.
Is a 300 watt subwoofer good?
300w RMS is more than enough for this car. Unless youre a bass head so it probably also depends what youre coming from. Its similar to a turbo - cars slow, you want a turbo, you get it, your car feels super fast, then after a while you want MOAR POWER!
What size wire should I use for subwoofers?
to 16-gauge Jaeden, For wiring subwoofers, we recommend using wires of 12- to 16-gauge in size. There will be no audible difference between them - just less power loss with larger wire.
Why does my left speaker sound louder than my right?
The reason is that the inherent meter tolerance when reading a noise signal means the two speakers will always end up being slightly different — enough to pull the phantom centre off slightly to one side.
What to do if one speaker is louder than the other?
Switch the left and right cables (i.e. left to right and right to left) from source -> amp. If the low volume moves to the opposite side, its either the cables or the source. If the low volume doesnt swap sides, its either the amp or the phones.