As long as both amps are grounded to the same spot you should be able to avoid ground loop. Runing to a distro or running both grounds to the same spot ends up with the same result.

Can 2 amps share the same power?

The short answer is that you can use any number or combination of power amps in a car audio setup as long as you wire them in properly. The most common reason to wire in multiple amps is to have one for your main speakers and a second amplifier for a subwoofer.

Can I hook up two amps to one sub?

Can I connect two amps to one sub? A single voice coil sub wont work with the two amps and will result in the outputs being fried as soon as you turn it on. A dual voice sub and the same amps can be done, but it needs to be effectively balanced. However, two amps one sub is definitely possible.

How do you strap two amps together?

0:576:07HOW TO Strap Amps - Linking Two Strappable Mono Amps!!! - YouTubeYouTubeStart of suggested clipEnd of suggested clipJust go ahead and hook up the co-main signal RCAs so be sure to check for a master slave switch onMoreJust go ahead and hook up the co-main signal RCAs so be sure to check for a master slave switch on the amp these amps dont actually have a switch.

Can you run 2 amps off capacitor?

A1: No, there isnt any trick to wiring two amps to one capacitor. Connect the negative terminal of the capacitor to ground. NOTE: The capacitor should be mounted as close as possible to your amplifiers. Connect the positive terminal of each amplifier to the positive terminal of the power capacitor.

Can you ground an amp and a capacitor to the same spot?

Can you ground a capacitor and AMP together? You ground both the amp and the cap to a single point on the chassis. The only wire going from the cap to the amp should be +.

How many amps can you strap together?

For the most part, “Strapping” – aka Bridging – TWO amps together is done to get Double the @1ohm Power Rating of One Amp. This makes the setup – AFTER “strapping” – stable ONLY to a 2-ohm final load .

Is it better to bridge an amp?

Bridging an amplifier increases the power that can be supplied to one loudspeaker, but it does not increase the amplifiers total available power. Because a bridge amplifier operates in mono mode, a second identical amplifier is required for stereo operation. For bridged amplifiers, damping factor is cut in half.

Is a capacitor needed for subs?

But most of the reason for adding capacitors is to keep your car voltage stable. Before considering capacitors, ensure you have adequate battery and alternator power for the total amperage of your audio system, and check your wiring to be sure you have adequate sized wire.

Will a bad ground make your amp hot?

There are several different reasons that an amplifier will get hot and shut down. Four of the most common are: Blown/grounded speaker(s), poor power and/or ground connections, too low an impedance (load), or Gain/Punch Bass control settings too high.

How do I connect two amps to a capacitor?

Questions and AnswersRun one power wire, large enough to effectively carry the current load of both amplifiers, to your amp rack. Connect the other end of this main power wire to the positive terminal of your capacitor. Connect the positive terminal of each amplifier to the positive terminal of the power capacitor.

Can I use a capacitor as a distribution block?

Perfectly fine to do so.